Service 01

GPR scanning and instrumentation: robotics and AI in the workflow

Field data that an engineer can act on: ground-penetrating radar, instrumentation programs, robotic and automated capture, and AI applied to the results.

Dial gauge on a reference tripod beside a hydraulic jack during a proof load test
Who it's for

Who this is for

  • Owners and contractors who need to know what is in a slab, a wall, or the ground before they cut, core, or dig
  • Public agencies and CM firms running monitoring programs on sensitive work
  • Engineering firms that want the data collected, reduced, and reported without building the capability in-house
Deliverables

What you receive

  • GPR scan reports with marked-up plans and photos, delivered the same day where the scope allows
  • Instrumentation plans, installation, baselines, thresholds, and reports an agency will accept
  • Data reduced and plotted by AI under PE direction, reviewed before it leaves the office
  • Automated capture where a crew would otherwise walk it: photogrammetry, scans, repeat surveys
How we work it

Field data, automated

We treat instrumentation and scanning as engineering, not as a service call. The scope is written by an engineer who knows what the data has to answer, the field work is done by qualified field staff, and the reduction is handled by AI tooling under a Professional Engineer’s direction, then reviewed before it goes out.

That last step is the difference. Automated capture and AI reduction make the turnaround short and the fee lean. The PE review is what makes the report something you can put in front of an agency, an owner, or a court.

GPR is an interpretation of the signal, so every scan report marks what the radar shows and flags what it cannot see: depth, congestion, and moisture all set limits, and we say where they apply.

If the question is “what is in there” or “is it moving,” this is the service line to start with.

Representative scopes

The kind of work this covers

  • GPR scanning of slabs, walls, and decks for rebar, conduit, post-tensioning, and voids before coring or cutting
  • Subsurface GPR for utilities, tanks, and voids ahead of excavation
  • Settlement, tilt, crack, and groundwater instrumentation on excavations beside existing structures
  • Repeat condition surveys with robotic or automated capture and AI-assisted change detection

Project references on this site are anonymized. See project experience.

Fixed fee

Packages for this service

A defined scope, deliverable, and fee, known before the work starts. Start with the free consultation.

Start here

Free 30-minute consultation

Free

What's included

  • A call with an engineer about the condition, the site, or the scope
  • Narrowing the scope and settling the approach
  • Confirming the fee and the schedule

What you receive

A written scope and fee, or a plain answer that you do not need us.

Anticipated turnaround*

Within 1 business day

Fixed fee

GPR survey of a concrete slab or wall for steel reinforcement

Fee on request

What's included

  • Ground-penetrating radar scan of the slab or wall areas you mark
  • Reinforcement, conduit, and void locations marked on the surface
  • Photos of the marked areas

What you receive

A marked-up concrete section showing what was found and where, so you can core, cut, or anchor with confidence. GPR is an interpretation of the signal: we mark what it shows and flag what it cannot see.

Anticipated turnaround*

Same day

*Anticipated turnaround is an estimate, not a guarantee. The schedule is confirmed in the written proposal.

Tell us about the project.

A scope, a site, or a condition you need an answer on. We reply with a plan and a fixed fee where one applies.

Call 201.632.3722